Deadpoint holds
Deadpoint holds that come in a set of 2 holds consisting of one incut hold and a blocking hold. These holds are designed to improve dynamic accuracy when deadpointing.
The blocking hold should be placed close enough to the incut hold to encourage accurate hand movement.
Incut to suit the steepeness of your board
Approximately 16cm diameter, 30-35mm deep.
Available in sets of 2, 4, 6 or 8.
5mm countersunk screw fixings (not included)
PRODUCT INSTALLATION
When installing, use only 5mm screws for the 5mm fixing option, and M10 bolts for the bolted option where available.
Be careful not to overtighten as especially on the smaller holds there is the possibility of overtightening the hold and splitting it. This risk is greatly reduced on the holds with brass cups which is why these are usually included on the smaller holds. If possible, tighten by hand, especially for smaller holds, and if you use a powered driver, be slow and gentle!
RETURN & REFUND POLICY
If you're not happy with your purchase, no problem! Get it back to us in the same condition it went out as and we will happily refund within 7 days of the return.
If there are any defects with the product, please contact us to discuss how we will resolve for you.
SHIPPING INFO
Despatch is as soon as possible. For current despatch times, see the shipping and returns section
If there are any delays, you will be contacted.
Second class post. If you have specific requirements, please email info@strongholds.co.uk with more information.
Thank you!